Nissan Juke Service and Repair Manual : Symptom diagnosis

NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING

NVH Troubleshooting Chart

Use the chart below to find the cause of the symptom. The numbers indicate the order of the inspection. If necessary, repair or replace these parts.

Periodic maintenance


    DTC/Circuit diagnosis
    POSITION SWITCH BACK-UP LAMP SWITCH : Component Inspection 1.CHECK BACK-UP LAMP SWITCH 1. Disconnect position switch connector. Refer to TM-24, "Removal and Installation". 2. Check con ...

    Periodic maintenance
    GEAR OIL ...

    Other materials:

    P2122, P2123 APP sensor
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P2122 or P2123 is displayed with DTC P0643, first perform the trouble diagnosis for DTC P0643. Refer to EC-686, "DTC Logic". DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, alw ...

    P0605 ECM
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.PERFORM DTC CONFIRMATION PROCEDURE ...

    On Board Diagnosis (OBD) System of CVT and Engine
    The ECM has an on board diagnostic system. It will light up the malfunction indicator lamp (MIL) to warn the driver of a malfunction causing emission deterioration. CAUTION: • Be sure to turn the ignition switch OFF and disconnect the battery cable from the negative terminal before any rep ...