Nissan Juke Service and Repair Manual : Symptom diagnosis

NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING

NVH Troubleshooting Chart

Use the chart below to find the cause of the symptom. If necessary, repair or replace these parts.

×: Applicable


×: Applicable

    Precaution
    Service Notice or Precautions for Rear Propeller Shaft • Replace the propeller shaft assembly if there is a breakage or deflection on tube. • Never hit the tube or apply an impact on it during rep ...

    Periodic maintenance
    REAR PROPELLER SHAFT Inspection APPEARANCE AND NOISE • Check the propeller shaft tube surface for dents or cracks. If damaged, replace propeller shaft assembly. • If center bearing is noisy or d ...

    Other materials:

    B2196 dongle unit
    Description BCM performs ID verification between BCM and dongle unit. When verification result is OK, BCM permits cranking. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Turn ignition switch OFF. 3. Turn igni ...

    Engine protection control at low engine oil pressure
    Engine protection control at low engine oil pressure : System Diagram Engine protection control at low engine oil pressure : System Description INPUT/OUTPUT SIGNAL CHART SYSTEM DESCRIPTION • The engine protection control at low engine oil pressure warns the driver of a decrease in engine ...

    P1550 battery current sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON. 3. ...