Microphone

Removal and Installation REMOVAL 1. Remove headlining. Refer to INT-26, "Exploded View". 2. Remove microphone connector and pawl to remove microphone. INSTALLATION Install in the reve ...

USB connector and aux jack

Removal and Installation REMOVAL 1. Remove cluster tray. Refer to IP-12, "Exploded View". 2. Push the pawl from the back of cluster tray to remove USB connector and AUX jack. INSTALL ...

Other materials:

Drive belt
Checking • Inspection should be done only when engine is cold or over 30 minutes after the engine is stopped. 1 : Alternator 2 : Water pump 3 : Crankshaft pulley 4 : A/C compressor 5 : Idler pulley 6 : Drive belt • Visually check belts for wear, damage, and cracks on inside and edge ...

Diagnosis and repair workflow
Work Flow OVERALL SEQUENCE DETAILED FLOW 1.INTERVIEW FOR MALFUNCTION Interview the symptom to the customer >> GO TO 2. 2.SYMPTOM CHECK Check the symptom from the customer's information. Check that any symptom occurs other than the interviewed symptom. Insufficient cooling/heat ...

Anti-hijack function does not operate
Diagnosis Procedure 1.CHECK “DOOR LOCK–UNLOCK SET” SETTING IN “WORK SUPPORT” 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “DOOR LOCK-UNLOCK SET” in “WORK SUPPORT” mode. 3. Check “DOOR LOCK-UNLOCK SET” in “WORK SUPPORT” Refer to DLK-41, "DOOR ...