Nissan Juke Service and Repair Manual : USB connector and aux jack

Removal and Installation

REMOVAL

1. Remove cluster tray. Refer to IP-12, "Exploded View".

2. Push the pawl from the back of cluster tray to remove USB connector and AUX jack.

INSTALLATION

Install in the reverse order of removal.

    Steering switch
    Exploded View Refer to SR-13, "Exploded View". Removal and Installation REMOVAL Refer to SR-13, "Removal and Installation". INSTALLATION Install in the reverse order of rem ...

    Antenna feeder
    Feeder Layout ...

    Other materials:

    P1544 EGT sensor 2
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P1544 is displayed with DTC P0115, first perform trouble diagnosis for DTC P0115. Refer to EC-907, "DTC Logic". Diagnosis Procedure 1.CHECK GROUND CONNECTIONS 1. Turn ignition switch OFF. 2. Check ground connection E38. Refer to Ground ...

    B26F7 BCM
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Press door request switch. 2. Turn ignition switch ON. 3. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III. Is DTC detected? YES >> Go to SEC-127, "Dia ...

    System
    Relay control system RELAY CONTROL SYSTEM : System Diagram *1: Except for MR16DDT engine models *2: For MR16DDT engine models RELAY CONTROL SYSTEM : System Description IPDM E/R activates the internal control circuit to perform the relay ON-OFF control according to the input signals from va ...