Nissan Juke Service and Repair Manual : Service data and specifications (SDS)

Cylinder block
Disassembly and Assembly PREPARING USED ENGINE The engine should be cleaned and drained (oil and water). Leave on the used engine or include in the return box: • Oil filter • Oil pressure switc ...

Other materials:

Interior room lamp control system
Wiring Diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation: if not described in wiring diagram), refer to GI-12, "Connector Information/Explanation of Option Abbreviation". ...

Combination switch input circuit
Diagnosis Procedure 1.CHECK INPUT 1 - 5 CIRCUIT FOR OPEN 1. Turn ignition switch OFF. 2. Disconnect BCM and combination switch connectors. 3. Check continuity between BCM harness connector and combination switch harness connector. Does continuity exist? YES >> GO TO 2. NO >> ...

P0720 output speed sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Be careful of the driving speed. 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. > ...