Nissan Juke Service and Repair Manual : General Specification

Tightening torque


    Tightening torque
    UPPER ENGINE *1: Refer to tightening procedure in the text. BOTTOM ENGINE *1: Refer to tightening procedure in the text. ...

    Other materials:

    Malfunction indicator lamp
    Component Function Check 1.CHECK MIL FUNCTION 1. Turn ignition switch ON. 2. Check that MIL lights up. Is the inspection result normal? YES >> INSPECTION END NO >> Proceed to EC-436, "Diagnosis Procedure". Diagnosis Procedure INFOID:0000000006547250 1.CHECK DTC Che ...

    P1840 output speed signal
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC CONFIRMATION PROCEDURE has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With ...

    Removal and Installation
    REMOVAL 1. Remove rear propeller shaft assembly. Refer to DLN-121, "Removal and Installation". 2. Remove rear drive shaft. Refer to RAX-17, "Removal and Installation". 3. Disconnect sub-harness connector (1). 4. Remove rear final drive breather hose. 5. Support rear final ...