Front suspension member

Exploded View 2WD 1. Front suspension member 2. Damper assembly* 3. Rebound stopper rubber 4. Washer 5. Member stay 6. Rebound stopper : N·m (kg-m, ft-lb) *: For K9K models 4WD 1. ...

Wheel Alignment

2WD Measure value under unladen*2 conditions. *1: A difference when assuming the left side a standard. *2: Fuel, engine coolant and lubricant are full. Spare tire, jack, hand tools and mats a ...

Other materials:

CVT fluid
Inspection CHECKING CVT FLUID The fluid level should be checked with the fluid warmed up to 50 to 80°C (122 to 176°F). The fluid level check procedure is as follows: 1. Check for fluid leakage. 2. With the engine warmed up, drive the vehicle in an urban area. When ambient temperature is ...

B2196 dongle unit
Description BCM performs ID verification between BCM and dongle unit. When verification result is OK, BCM permits cranking. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Turn ignition switch OFF. 3. Turn igni ...

Parts Requiring Angle Tightening
• Use the angle wrench [SST: KV10112100] for the final tightening of the following engine parts: - Cylinder head bolts - Lower cylinder block bolts - Connecting rod cap bolts - Crankshaft pulley bolt (No the angle wrench is required as bolt flange is provided with notches for angle tighte ...