Wheel Alignment

2WD Measure value under unladen*2 conditions. *1: A difference when assuming the left side a standard. *2: Fuel, engine coolant and lubricant are full. Spare tire, jack, hand tools and mats a ...

Wheelarch Height

2WD Measure value under unladen* conditions. *: Fuel, engine coolant and lubricant are full. Spare tire, jack, hand tools and mats are in designated positions. 4WD Measure value un ...

Other materials:

Diagnosis system (IPDM E/R) (without intelligent key system)
Diagnosis Description AUTO ACTIVE TEST Description In auto active test mode, the IPDM E/R sends a drive signal to the following systems to check their operation. • Oil pressure warning lamp (only for K9K engine models) • Rear window defogger • Front wiper motor • Parking lamp • ...

LAN System can system (type 3)
DTC/circuit diagnosis Main line between IPDM-E and DLC circuit Diagnosis Procedure 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (connector s ...

B210C starter control relay
DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B210C is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to PCS-30, "DTC Logic". • When IPDM E/R power supply voltage is low (Approx. 7 - 8 V for about 1 second), the DTC B210C may be detected. ...