Unit removal and installation

TRANSMISSION ASSEMBLY Exploded View 1. Transaxle assembly A: : For the tightening torque, refer to TM-508, "Removal and Installation". Removal and Installation REMOVAL WARNING: Neve ...

General Specification

CAUTION: • Use only Genuine NISSAN CVT Fluid NS-2. Never mix with other fluid. • Use only Genuine NISSAN CVT Fluid NS-2. Using transmission fluid other than Genuine NISSAN CVT Fluid NS-2 will da ...

Other materials:

Forward-facing child restraint installation using the seat belts
WARNING The three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not being properly secured. The restraint could tip over or be loose and cause injury to a child in a sudden ...

B2014 chain of STRG-IMMU
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Lock steering. NOTE: 3. Press the push-button ignition switch. 4. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III. Is DTC detected? YES >> Go to SEC-70, " ...

DTC/Circuit diagnosis
POSITION SWITCH BACK-UP LAMP SWITCH : Component Inspection 1.CHECK BACK-UP LAMP SWITCH 1. Disconnect position switch connector. Refer to TM-24, "Removal and Installation". 2. Check continuity between position switch terminals. Is the inspection result normal? YES >> INSPE ...