Symptom diagnosis

INTERIOR LIGHTING SYSTEM SYMPTOMS Symptom Table CAUTION: Perform the self-diagnosis with CONSULT-III before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected. ...

Map lamp

Exploded View 1. Map lamp bulb housing 2. Bulb 3. Lens : Pawl Removal and Installation CAUTION: Disconnect the battery negative terminal or the fuse. REMOVAL 1. Remove the lens (1). • In ...

Other materials:

Both side headlamps (LO) are not turned on
Description Both side headlamps (LO) are not turned ON in any condition. Diagnosis Procedure 1.CHECK COMBINATION SWITCH Check the combination switch. Refer to BCS-92, "Symptom Table". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace the malfun ...

Additional service when replacing control unit
Description BEFORE REPLACEMENT When replacing BCM, save or print current vehicle specification with CONSULT-III configuration before replacement. NOTE: If “READ CONFIGURATION” can not be used, use the “WRITE CONFIGURATION - Manual selection” after replacing BCM. AFTER REPLACEMENT CAU ...

C1110, C1170 ABS actuator and electric unit (control unit)
DTC Logic DTC DETECTION LO DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CONSULT-II ...