Nissan Juke Service and Repair Manual : Removal and installation

Symptom diagnosis
Squeak and rattle trouble diagnoses Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet ...

Windshield glass
Exploded View 1. Windshield glass molding 2. Dam rubber (upper) 3. Upper clip 4. Windshield glass 5. Dam rubber (lower) 6. Lower clip 7. Mirror base 8. Rain sensor bracket 9. Adhesive ...

Other materials:

P0605 ECM
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

P2100, P2103 throttle control motor relay
DTC Logic DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON. 3. Turn ignitio ...

P0730 incorrect gear ratio
Description TCM selects the gear ratio using the engine load (throttle position), the primary pulley revolution speed, and the secondary pulley revolution speed as input signal. Then it changes the operating pressure of the primary pulley and the secondary pulley and changes the groove width ...