Parking brake shoe

Adjustment 1. Adjust parking brake lever stroke. Refer to PB-2, "Inspection and Adjustment". 2. Perform parking brake break-in (drag on) operation by driving vehicle under the followin ...

Parking brake control

Exploded View 2WD 1. Parking brake lever assembly 2. Adjusting nut 3. Parking brake switch 4. Front cable 5. Rear cable (LH) 6. Rear cable (RH) : Apply multi-purpose grease. : N·m (kg-m ...

Other materials:

P0197, P0198 EOT sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

Rear combination lamp
Exploded View REMOVAL 1. Grommet 2. Grommet 3. Rear combination lamp : Clip : N·m (kg-m, in-lb) DISASSEMBLY 1. Rear combination lamp housing assembly 2. Back-up lamp bulb 3. Harness connector 4. Rear turn signall lamp bulb 5. Stop/tail lamp bulb Removal and Installation CAUTIO ...

Auto operation does not operate but manual operate normally (driver side)
Diagnosis Procedure 1.PERFORM INITIALIZATION PROCEDURE Initialization procedure is executed and operation is confirmed. Refer to PWC-16, "Work Procedure". Is the inspection result normal? YES >> INSPECTION END NO >> GO TO 2. 2.CHECK ENCODER CIRCUIT Check encoder c ...