Periodic maintenance

REAR PROPELLER SHAFT Inspection APPEARANCE AND NOISE • Check the propeller shaft tube surface for dents or cracks. If damaged, replace propeller shaft assembly. • If center bearing is noisy ...

Exploded View

1. Propeller shaft assembly : Vehicle front : N·m (kg-m, ft-lb) : Always replace after every disassem ...

Other materials:

Evaporative emission system
Inspection 1. Visually inspect EVAP vapor lines for improper attachment and for cracks, damage, loose connections, chafing and deterioration. 2. Check EVAP canister as follows: a. Block port (A). Orally blow air through port (B). Check that air flows freely through port (C). b. Block port (B ...

Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW (METER SYSTEM) Work flow OVERALL SEQUENCE • Reference 1···MWI-22, "On Board Diagnosis Function". • Reference 2···MWI-36, "DTC Index". • Reference 3···MWI-51, "COMBINATION METER : Diagnosis Procedure". DETAILED FLOW ...

P0340 CMP sensor (PHASE)
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...