Nissan Juke Service and Repair Manual : Exploded View

1. Propeller shaft assembly


1. Propeller shaft assembly

: N·m (kg-m, ft-lb): Vehicle front
: Always replace after every: N·m (kg-m, ft-lb)
disassem: Always replace after every
disassem

    Removal and installation
    REAR PROPELLER SHAFT ...

    Removal and Installation
    REMOVAL 1. Shift the transaxle to the neutral position, and then release the parking brake. 2. Put matching marks on propeller shaft flange yoke and final drive companion flanges. CAUTION: F ...

    Other materials:

    The braking distance is long
    Description Brake stopping distance is long when ABS function is operated. Diagnosis Procedure CAUTION: Brake stopping distance on slippery road like rough road, gravel road or snowy road may become longer when ABS is operated than when ABS is not operated. 1.CHECK BRAKING FORCE Check bra ...

    Line pressure test
    Inspection and Judgment INSPECTION Line Pressure Test Port Line Pressure Test Procedure 1. Inspect the amount of engine oil and replenish if necessary. 2. Drive the car for about 10 minutes to warm it up so that the CVT fluid reaches in the range of 50 to 80°C (122 to 176°F), then inspec ...

    P1643 thermoplunger control unit
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK THERMOPLUNGER CONTROL UNIT POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect thermoplunger control unit harness connector. 3. Check the voltage between thermoplunger control unit harness connector and ground. Is the ...