Nissan Juke Service and Repair Manual : Removal and Disassembly

• When instructed to use SST, use specified tools. Always be careful to work safely, avoid forceful or uninstructed operations.

• Exercise maximum care to avoid damage to mating or sliding surfaces.

• Dowel pins are used for several parts alignment. When replacing and reassembling parts with dowel pins, check that dowel pins are installed in the original position.

• Cover openings of engine system with a tape or equivalent, if necessary, to seal out foreign materials.

• Mark and arrange disassembly parts in an organized way for easy troubleshooting and reassembly.

• When loosening nuts and bolts, as a basic rule, start with the one furthest outside, then the one diagonally opposite, and so on. If the order of loosening is specified, do exactly as specified. Power tools may be used in the step.

    Disconnecting Fuel Piping
    • Before starting work, check no fire or spark producing items are in the work area. • Release fuel pressure before disconnecting and disassembly. • After disconnecting pipes, plug openings ...

    Inspection, Repair and Replacement
    Before repairing or replacing, thoroughly inspect parts. Inspect new replacement parts in the same way, and replace if necessary. ...

    Other materials:

    ASCD indicator
    Component Function Check 1.CHECK ASCD INDICATOR FUNCTION Check ASCD indicator under the following conditions. Is the inspection result normal? YES >> INSPECTION END NO >> Go to EC-767, "Diagnosis Procedure". Diagnosis Procedure 1.CHECK DTC Check that DTC UXXXX is not ...

    Meter buzzer circuit
    Component Function Check 1.CHECK OPERATION OF METER BUZZER 1. Select “BUZZER” of “BCM” on CONSULT-III. 2. Perform “LIGHT WARN ALM” of “Active Test”. Does meter buzzer beep? YES >> INSPECTION END NO >> GO TO 2. 2.CHECK COMBINATION METER INPUT SIGNAL Select the ...

    P2138 APP sensor
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P2138 is displayed with DTC P0643, first perform the trouble diagnosis for DTC P0643. Refer to EC-307, "DTC Logic". DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform ...