Removal and Disassembly

• When instructed to use SST, use specified tools. Always be careful to work safely, avoid forceful or uninstructed operations. • Exercise maximum care to avoid damage to mating or sliding surface ...

Assembly and Installation

• Use torque wrench to tighten bolts or nuts to specification. • When tightening nuts and bolts, as a basic rule, equally tighten in several different steps starting with the ones in center, then ...

Other materials:

P1616 ECM
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION 1. Turn ignition switch ON amd wait 2 seconds or more. 2. Check DTC in “Self Diagnostic Result” mode of “ENGINE” using CONSULT-III. Is DTC detected? YES >> Go to SEC-199, &q ...

Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always use CONS ...

Diagnosis and repair workflow
Gasoline engine models GASOLINE ENGINE MODELS : Work Flow OVERALL SEQUENCE DETAILED FLOW 1.PRELIMINARY INSPECTION Perform the preliminary inspection. Refer to CHG-17, "Inspection Procedure". Models with battery current sensor>>GO TO 2. Models without battery current sens ...