Nissan Juke Service and Repair Manual : Assembly and Installation

• Use torque wrench to tighten bolts or nuts to specification.

• When tightening nuts and bolts, as a basic rule, equally tighten in several different steps starting with the ones in center, then ones on inside and outside diagonally in this order. If the order of tightening is specified, do exactly as specified.

• Replace with new gasket, packing, oil seal or O-ring.

• Thoroughly wash, clean, and air-blow each part. Carefully check engine oil or engine coolant passages for any restriction and blockage.

• Avoid damaging sliding or mating surfaces. Completely remove foreign materials such as cloth lint or dust. Before assembly, oil sliding surfaces well.

• Release air within route when refilling after draining engine coolant.

• After repairing, start the engine and increase engine speed to check engine coolant, fuel, engine oil, and exhaust gases for leakage.

    Inspection, Repair and Replacement
    Before repairing or replacing, thoroughly inspect parts. Inspect new replacement parts in the same way, and replace if necessary. ...

    Parts Requiring Angle Tightening
    • Use the angle wrench [SST: KV10112100] for the final tightening of the following engine parts: - Cylinder head bolts - Lower cylinder block bolts - Connecting rod cap bolts - Crankshaft pull ...

    Other materials:

    B257B, B257C ambient sensor
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC is displayed along with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to HAC- 275, "DTC Logic". • If DTC is displayed along with DTC U1010, first perform the trouble diagnosis for DTC U1010. HAC-276, "DTC ...

    Supplemental air bag warning light
    The supplemental air bag warning light, displaying in the instrument panel, monitors the circuits for the air bag systems, pretensioners and all related wiring. When the ignition switch is in the ON position, the supplemental air bag warning light illuminates for about 7 seconds and then tu ...

    Window washer fluid
    To fill the window washer fluid reservoir, lift the cap and pour the window washer fluid into the reservoir opening. Add a washer solvent to the washer for better cleaning. In the winter season, add a windshield washer antifreeze. Follow the manufacturer’s instructions for the mixture rat ...