Nissan Juke Service and Repair Manual : Disconnecting Fuel Piping

• Before starting work, check no fire or spark producing items are in the work area.

• Release fuel pressure before disconnecting and disassembly.

• After disconnecting pipes, plug openings to stop fuel leakage.

    Draining Engine Coolant
    Drain engine coolant and engine oil when the engine is cooled. ...

    Removal and Disassembly
    • When instructed to use SST, use specified tools. Always be careful to work safely, avoid forceful or uninstructed operations. • Exercise maximum care to avoid damage to mating or sliding sur ...

    Other materials:

    Electric controlled coupling
    Exploded View 1. Sub-harness 2. Rear final drive assembly 3. Electric controlled coupling (right) 4. Reamer bolt 5. Electric controlled coupling (left) A. Gear carrier mouting face : Vehicle front : N·m (kg-m, ft-lb) : Apply Genuine Liquid Gasket 1217 or equivalent. Removal and Ins ...

    P0112, P0113 IAT sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

    Hood lock
    Exploded View 1. Hood lock control cable assembly 2. Hood lock assembly : Clip : N·m (kg-m, ft-lb) : Body grease Hood lock HOOD LOCK : Removal and Installation REMOVAL 1. Remove front center grille. Refer to EXT-18, "Removal and Installation". 2. Remove crash zone sensor. Ref ...