Flushing

1. Install radiator drain plug. CAUTION: Be sure to clean drain plug and install with new O-ring. Radiator drain plug : Refer to CO-17, "Exploded View". • If water drain plugs on cyl ...

Radiator cap : Inspection

• Check valve seat (A) of radiator cap. B : Metal plunger - Check that valve seat is swollen to the extent that the edge of the plunger cannot be seen when watching it vertically from the top. - ...

Other materials:

Main line betweeN DLC and MDU circuit
Diagnosis Procedure 1.CHECK HARNESS CONTINUITY (OPEN CIRCUIT) 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect the following harness connectors. - ECM - Multi display unit 4. Check the continuity between the data link connector and the ...

Evap canister
2WD : Hydraulic Layout EVAPORATIVE EMISSION LINE DRAWING 1.EVAP canister purge volume control solenoid valve 2. EVAP canister 3. EAVP line 4. Fuel line NOTE: Do not use soapy water or any type of solvent while installing vacuum hose or purge hoses. 2WD : Removal and Installation REMOV ...

Water hose
Exploded View 1. Hose clamp 2. Water hose A. Water outlet B. Oil warm Removal and Installation REMOVAL WARNING: Never remove the radiator cap when the engine is hot. Serious burns could occur from high pressure coolant escaping from the radiator. CAUTION: Perform these steps after t ...