Work

• After removing and installing the opening/closing parts, be sure to carry out fitting adjustments to check their operational. • Check the lubrication level, damage, and wear of each part. If nec ...

System description

...

Other materials:

High-mounted stop lamp
Exploded View 1. High-mounted stop lamp 2. Seal packing : N·m (kg-m, in-lb) Removal and Installation CAUTION: Disconnect battery negative terminal or remove the fuse. REMOVAL 1. Remove blind seal from back door inside. CAUTION: Be careful not to damage the blind seal, so that it can b ...

Exhaust manifold
Exploded View 1. Stud bolt 2. Exhaust manifold cover 3. Exhaust manifold 4. Gasket Engine front : N·m (kg-m, ft-lb) : N·m (kg-m, in-lb) : Always replace after every disassembly. Removal and Installation REMOVAL 1. Drain engine coolant. Refer to CO-11, "Draining". 2. Remo ...

Assembly and Installation
• Use torque wrench to tighten bolts or nuts to specification. • When tightening nuts and bolts, as a basic rule, equally tighten in several different steps starting with the ones in center, then ones on inside and outside diagonally in this order. If the order of tightening is specified, do ...