Nissan Juke Service and Repair Manual : Precaution for Work

• After removing and installing the opening/closing parts, be sure to carry out fitting adjustments to check their operation.

• Check the lubrication level, damage, and wear of each part. If necessary, grease or replace it.

    Precaution for Procedure without Cowl Top Cover
    When performing the procedure after removing cowl top cover, cover the lower end of windshield with urethane, etc. ...

    Preparation
    Commercial Service Tools Clip List ...

    Other materials:

    Rear oil seal
    REAR OIL SEAL : Removal and Installation REMOVAL 1. Remove transaxle assembly. Refer to TM-301, "Exploded View" (CVT models) or TM-84, "MR16DDT : Exploded View" (M/T models). 2. Remove clutch cover and clutch disk (M/T models). Refer to CL-29, "EXCEPT FOR K9K : Explo ...

    Audio operation precautions
    Radio Place the ignition switch in the ACC or ON position and push the PWR (power/VOL (volume)) control to turn on the radio. If you listen to the radio with the engine not running, the ignition switch should be placed in the ACC position. Radio reception is affected by station signal strength ...

    C1144 incomplete steering angle sensor adjustment
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CON ...