Nissan Juke Service and Repair Manual : Precaution for Procedure without Cowl Top Cover
When performing the procedure after removing cowl top cover, cover the lower end of windshield with urethane, etc.
Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE:
• Before removing and installing any control units, first turn the ignition
switch to the LOCK position, then disconnect
both battery cables.
• After finishing work, confirm that all co ...
Precaution for Work
• After removing and installing the opening/closing parts, be sure to carry
out fitting adjustments to check their
operation.
• Check the lubrication level, damage, and wear of each part. If n ...
Other materials:
Keyfob battery
Exploded View
1. Upper case
2. Key
3. Switch cover
4. Switch rubber
5. Board surface
6. Battery
7. plate
8. Lower case
9. Screw
Removal and Installation
REMOVAL
1. Remove screw (9) on the rear of keyfob.
2. Place the key with the lower case (8) facing up. Set a screw-driver wrap ...
Light & rain sensor
Exploded View
1. Light & rain sensor bracket
2. Mirror base
3. Light & rain sensor
4. Inside mirror assembly
: Pawl
: Do not reuse
Removal and Installation
CAUTION:
When the light & rain sensor is removed from windshield, the light & rain sensor
cannot be reused.
REMO ...
Opening charge port lid
Instrument panel switch
When opening the charge port lid to plug in a charging connector, perform one of the following official interface actions:
Push the physical charge port lid switch located on the lower instrument panel to the left of the steering ...
