Precaution for Work

• After removing and installing the opening/closing parts, be sure to carry out fitting adjustments to check their operation. • Check the lubrication level, damage, and wear of each part. If neces ...

Symptom diagnosis

Squeak and rattle trouble diagnoses Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet ...

Other materials:

Key reminder function does not operate
Diagnosis Procedure 1.CHECK DTC WITH BCM Check that DTC is not detected with BCM. Is the inspection result normal? YES >> GO TO 2. NO >> Refer to BCS-67, "DTC Index". 2.CHECK “ANTI KEY LOCK IN FUNCTI” SETTING IN “WORK SUPPORT” 1. Select “INTELLIGENT KEY” of “BCM” u ...

B1154, B1155, B1156, B1157, B1158, B1159 diagnosis sensor unit
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...

S mode indicator
Component Function Check 1.CHECK S MODE INDICATOR FUNCTION Check S mode indicator turns ON for approx. 2 seconds when ignition switch turns ON. Is the inspection results normal? YES >> INSPECTION END NO >> Go to TM-469, "Diagnosis Procedure". Diagnosis Procedure 1.CH ...