Precaution Necessary for Steering Wheel Rotation after Battery Disconnect

NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all contro ...

Work

• After removing and installing the opening/closing parts, be sure to carry out fitting adjustments to check their operational. • Check the lubrication level, damage, and wear of each part. If nec ...

Other materials:

P0840 transmission fluid pressure SEN/SW A
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test. After the repair, perform the following procedure to confirm the mal ...

Brake pad wear warning
The disc brake pads have audible wear warnings. When a brake pad requires replacement, it will make a high pitched scraping sound when the vehicle is in motion. This scraping sound will first occur only when the brake pedal is depressed. After more wear of the brake pad, the sound will always ...

Headlight switch
Lighting 1 Turn the switch to the position: The front parking, side marker, tail, license plate, instrument lights and daytime running lights (for NISMO models) will come on. 2 Turn the switch to the position: Headlights will come on and all the other lights remain on. However, the daytime ...