Engine Lubrication System Schematic

WITH OIL COOLER WITHOUT OIL COOLER ...

Engine oil

Inspection ENGINE OIL LEVEL NOTE: Before starting engine, put vehicle horizontally and check the engine oil level. If engine is already started, stop it and allow 10 minutes before checking. ...

Other materials:

Hood switch
Component Function Check 1.CHECK FUNCTION 1. Select “HOOD SW” in “Data Monitor” mode of “IPDM E/R” using CONSULT-III. 2. Check “HOOD SW” indication under the following condition. Is the indication normal? YES >> Hood switch is OK. NO >> Go to SEC-223, "Diag ...

Shift P warning lamp
Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “LCD” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Shift P ...

P183A coupling temperature sensor right
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE W ...