Symptom diagnosis

NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING NVH Troubleshooting Chart Use the chart below to find the cause of the symptom. If necessary, repair or replace these parts. ×: Applic ...

Brake pedal

Inspection and Adjustment INSPECTION Brake Pedal Height Check the height (H1) between the dash lower panel (1) and the brake pedal upper surface. H1 : Refer to BR-136, "Brake Pedal". C ...

Other materials:

Nats antenna AMP
Removal and Installation REMOVAL 1. Remove the cluster lid A. Refer to IP-13, "Removal and Installation". 2. Remove the NATS antenna amp. 1. Disengage the NATS antenna amp. (1) fixing pawls using minus driver etc. 2. Pull NATS antenna amp. to remove it from push-button ignition sw ...

P0131 A/F sensor 1
DTC Logic DTC DETECTION LOGIC To judge the malfunction, the diagnosis checks that the A/F signal computed by ECM from the A/F sensor 1 signal is not inordinately low. DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform ...

B1051, B1056 driver air bag module
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...