Nissan Juke Service and Repair Manual : Brake master cylinder

Inspection

FLUID LEAK

Check for brake fluid leakage from the master cylinder mounting face, reservoir tank mounting face and brake tube connections.

    Brake fluid
    Inspection BRAKE FLUID LEVEL • Check that the fluid level in the reservoir tank is within the specified range (MAX – MIN lines). • Visually check for any brake fluid leakage around the reservoir ...

    Brake booster
    Inspection OPERATION Depress the brake pedal several times at 5-second intervals with the engine stopped. Start the engine with the brake pedal fully depressed. Check that the clearance between b ...

    Other materials:

    Environmental factors influence the rate of corrosion
    Moisture Accumulation of sand, dirt and water on the vehicle body underside can accelerate corrosion. Wet floor coverings will not dry completely inside the vehicle, and should be removed for drying to avoid floor panel corrosion. Relative humidity Corrosion will be accelerated in areas of h ...

    Oil pan
    Exploded View 1. Transaxle assembly 2. Oil pan gasket 3. Magnet 4. Oil pan 5. Overflow tube 6. Drain plug gasket 7. Drain plug 8. Oil pan fitting bolt : Always replace after every disassembly. : N·m (kg-m, ft-lb) : N·m (kg-m, it-lb) Removal and Installation REMOVAL 1. Remove t ...

    Auto retractable door mirror circuit
    Component Function Check 1.CHECK FUNCTION 1. Turn the door mirror open/close switch to “AUTO”. 2. Turn ignition switch ON. 3. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 4. Select “RETRACTABLE MIRROR” in “ACTIVE TEST” mode. 5. Touch “On” check that it works normally. Is the inspect ...