Symptom diagnosis

NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING NVH Troubleshooting Chart Use chart below to find the cause of the symptom. If necessary, repair or replace these parts. ×: Applicable ...

Front wheel hub and knuckle

Inspection COMPONENT PART Check that the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are normal. WHEEL HUB ASSEMBLY (BEARING-INTEGRATED ...

Other materials:

P1740 select solenoid
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test. After the repai ...

System
System Description SYSTEM DIAGRAM • The multi display unit transmits the operation status of the drive mode switch to other units via CAN communication as the mode signal (refer below). - NORMAL: ON/OFF - SPORT: ON/OFF - ECO: ON/OFF • Based on the mode signals received from TCM (CVT ...

Adjust
For adjustable head restraint/headrest Adjust the head restraint/headrest so the center is level with the center of your ears. If your ear position is still higher than the recommended alignment, place the head restraint/headrest at the highest position. For non-adjustable head restraint/h ...