Nissan Juke Service and Repair Manual : Front wheel hub and knuckle

Inspection

COMPONENT PART

Check that the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are normal.

WHEEL HUB ASSEMBLY (BEARING-INTEGRATED TYPE)

Check the following items, and replace the part if necessary.

• Move wheel hub assembly in the axial direction by hand. Check there is no looseness of wheel bearing.

Axial end play : Refer to FAX-60, "Wheel Bearing".

• Rotate wheel hub assembly and check there is no unusual noise or other irregular conditions. If there is any of irregular conditions, replace wheel hub assembly.

    Front drive shaft
    Inspection Check the following items, and replace the part if necessary. • Check drive shaft mounting point and joint for looseness and other damage. CAUTION: Replace entire drive shaft asse ...

    Other materials:

    Brake warning lamp
    Component Function Check 1.CHECK BRAKE WARNING LAMP FUNCTION (1) Check that brake warning lamp in combination meter turns ON for approx. 1 second after ignition switch is turned ON. CAUTION: Never start engine. Is the inspection result normal? YES >> GO TO 2. NO >> Proceed ...

    Push-button ignition switch (models with Intelligent Key system)
    WARNING Do not operate the push-button ignition switch while driving the vehicle except in an emergency. (The engine will stop when the ignition switch is pushed 3 consecutive times or the ignition switch is pushed and held for more than 2 seconds.) If the engine stops while the vehicle is be ...

    S mode switch
    Component Function Check 1.CHECK S MODE INDICATOR FUNCTION Check S mode indicator turns ON for approx. 2 seconds when ignition switch turns ON. Is the inspection results normal? YES >> GO TO 2. NO >> Go to TM-469, "Diagnosis Procedure". 2.CHECK S MODE SWITCH FUNCT ...