Nissan Juke Service and Repair Manual : P2226 baro sensor

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure


Diagnosis Procedure

1.REPLACE ECM

Perform EC-879, "Work Procedure".

>> INSPECTION END

    P2120 APP sensor
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK GROUND CONNECTIONS 1. Turn ignition switch OFF. 2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit In ...

    P2263 TC system
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK VACUUM HOSES AND VACUUM GALLERY 1. Turn ignition switch OFF. 2. Check vacuum hoses and vacuum gallery for clogging, cracks or improper ...

    Other materials:

    Operation inspection
    Work Procedure The purpose of the operational check is to check that the individual system operates normally. Check condition : Engine running at normal operating temperature. 1.CHECK BLOWER MOTOR 1. Operate fan control dial. 2. Check that fan speed changes. Check operation for all fan speeds ...

    Center stem assembly
    Exploded View 1. Filler plug 2. Gasket 3. Drain plug 4. Breather tube 5. Clip 6. Breather hose 7. Breather 8. sub-harness clip 9. sub-harness 10. Rear cover 11. Center stem 12. Side bearing (right) 13. Side bearing adjusting shim (right) 14. Side oil seal (right) 15. Connec ...

    C1140 actuator relay system
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CONSULT ...