Nissan Juke Service and Repair Manual : P2002 diesel particulate filter

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure


Diagnosis Procedure

1.CHECK DIESEL PARTICULATE FILTER

Refer to EC-995, "Component Inspection".

OK or NG OK >> INSPECTION END

NG >> GO TO 2.

2.REPLACE DIESEL PARTICULATE FILTER

1. Replace diesel particulate filter.

2. Perform ???Diesel Particulate Filter Data Clear???. Refer to EC-884, "Work Procedure" >> INSPECTION END

Component Inspection

1.CHECK DIESEL PARTICULATE FILTER-I

1. Start engine and warm it up to normal operating temperature.

2. With engine running in neutral position, make 4 accelerations (wait at least 10 seconds between 2 accelerations).

3. Put white duster on exhaust line output.

4. With engine running in neutral position, make 1 acceleration.

5. Duster is still white.

Is the inspection result normal? YES >> INSPECTION END

NO >> GO TO 2.

2.CHECK DIESEL PARTICULATE FILTER-II

1. Put a new white duster.

2. With engine running in neutral position, make 10 accelerations.

3. Compare duster state with the first one (Step 1 - 5). If duster becames dark grey or black, diesel particulate filter is damaged.

Is the diesel particulate filter damaged? YES >> GO TO 3.

NO >> INSPECTION END

3.REPLACE DIESEL PARTICULATE FILTER

1. Replace diesel particulate filter.

2. Perform ???Diesel Particulate Filter Data Clear???. Refer to EC-884, "Work Procedure".

>> INSPECTION END

    P1650 thermoplunger control unit
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK THERMOPLUNGER CONTROL UNIT POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect thermoplunger control unit harness connector ...

    P2080 EGT sensor 1
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK GROUND CONNECTIONS 1. Turn ignition switch OFF. 2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit In ...

    Other materials:

    5TH injector
    Exploded View 1. 5th injector retaining bracket 2. 5th injector bolt 3. 5th injector 4. Injector seal 5. Diesel injector cooler 6. Gasket 7. Turbocharger outlet duct : N·m (kg-m, ft-lb) : Always replace after every disassembly. Removal and Installation REMOVAL CAUTION: • Be s ...

    Squeak and rattle trouble diagnoses
    Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any of the customer's comments; refer to DLK-139, &q ...

    Combination meter
    Reference Value VALUES ON THE DIAGNOSIS TOOL NOTE: Some items are not available according to vehicle specification. TERMINAL LAYOUT PHYSICAL VALUES Fail-Safe FAIL-SAFE The combination meter activates the fail-safe control if CAN communication with each unit is malfuncti ...