Nissan Juke Service and Repair Manual : P0263, P0266, P0269, P0272 fuel injector

DTC Logic

DTC DETECTION LOGIC

NOTE:


NOTE

:
Check injector code when the above DTC is indicated. If the code is normal, replace injector showing an applicable code. If the code is not normal, load injector codes and initialize the injector learning.

    P0226 APP sensor
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK GROUND CONNECTIONS 1. Turn ignition switch OFF. 2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit In ...

    P0335 CKP sensor (POS)
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK GROUND CONNECTIONS 1. Turn ignition switch OFF. 2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit In ...

    Other materials:

    Vacuum lines
    MR16DDT : Removal and Installation REMOVAL 1. Remove the vacuum hose and vacuum piping. 2. Perform inspection after removal. Refer to BR-115, "MR16DDT : Inspection". INSTALLATION Note the following, install the vacuum hose. • When installing vacuum hose, insert it until its tip ...

    B1083 seat belt Pre-tensioner RH
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning la ...

    P0340 CMP sensor (phase)
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK GROUND CONNECTIONS 1. Turn ignition switch OFF. 2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit Inspection". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or ...