Nissan Juke Service and Repair Manual : P0201, P0202, P0203, P0204 fuel injector

DTC Logic

DTC DETECTION LOGIC

NOTE:


NOTE

:

If DTC P0201, P0202, P0203 or P0204 is displayed with DTC P0263, P0266, P0269 or P0272 first perform trouble diagnosis for DTC P0263, P0266, P0269 or P0272. Refer to EC-931, "DTC Logic".

Diagnosis Procedure

1.CHECK FUEL INJECTOR POWER SUPPLY CIRCUIT FOR OPEN AND SHORT

1. Turn ignition switch OFF.

2. Disconnect ECM harness connector.

3. Disconnect fuel injector harness connector.

4. Check the continuity between fuel injector harness connector and ECM harness connector.

5. Also check harness for short to ground and short to power.


5. Also check harness for short to ground and short to power.

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair open circuit or short to ground or short to power in harness or connectors.

2.CHECK FUEL INJECTOR OUTPUT CIRCUIT FOR OPEN AND SHORT

1. Check the continuity between fuel injector harness connector and ECM harness connector.

2. Also check harness for short to ground and short to power.


2. Also check harness for short to ground and short to power.

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair open circuit or short to ground or short to power in harness or connectors.

3.CHECK FUEL INJECTOR

Refer to EC-922, "Component Inspection".

Is the inspection result normal? YES >> GO TO 4.

NO >> Replace malfunctioning fuel injector.

4.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident", ???INCIDENT SIMULATION TESTS??? and ???GROUND INSPECTION???.

>> INSPECTION END

Component Inspection

1.CHECK FUEL INJECTOR

1. Turn ignition switch OFF.

2. Disconnect fuel injector harness connector.

3. Check resistance between fuel injector terminals as follows.

Is the inspection result normal?


Is the inspection result normal? YES >> INSPECTION END

NO >> Replace malfunctioning fuel injector.

    P0200 fuel injector
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK FUEL INJECTOR POWER SUPPLY CIRCUIT FOR OPEN AND SHORT 1. Turn ignition switch OFF. 2. Disconnect ECM harness connector. 3. Disconnect ...

    P0217 engine over temperature
    DTC Logic DTC DETECTION LOGIC If the cooling fan or another component in the cooling system malfunctions, engine coolant temperature will rise. When the engine coolant temperature reaches an a ...

    Other materials:

    System
    Intelligent key system/engine start function INTELLIGENT KEY SYSTEM/ENGINE START FUNCTION : System Diagram INTELLIGENT KEY SYSTEM/ENGINE START FUNCTION : System SYSTEM DESCRIPTION • The engine start function of Intelligent Key system makes it possible to start and stop the engine without ...

    P17B5 low brake solenoid
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.CHECK DTC DETECTION 1. S ...

    Stall test
    Inspection and Judgment INSPECTION 1. Inspect the amount of engine oil. Replenish the engine oil if necessary. 2. Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 to 80°C (122 to 176°F). Inspect the amount of CVT fluid. Replenish if necessary. 3. Se ...