Nissan Juke Service and Repair Manual : P0016 CKP - CMP correlation

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure


Diagnosis Procedure

1.CHECK CKP SENSOR AND CMP SENSOR

Refer to EC-932, "Diagnosis Procedure" (CKP sensor) and EC-934, "Diagnosis Procedure" (CMP sensor).

>> INSPECTION END

    P0002 fuel pump
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P0002 is displayed with DTC P0087, P0089, P0090 or P0190, first perform trouble diagnosis for DTC P0087, P0089, P0090 or P0190. Refer to EC-895, " ...

    P0045 TC boost control solenoid valve
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK TURBOCHARGER BOOST CONTROL SOLENOID VALVE POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect turbocharger boost control so ...

    Other materials:

    Luggage room lamp
    Exploded View 1. Bulb housing 2. Bulb 3. Lens : Pawl Removal and Installation CAUTION: Disconnect the battery cable from negative terminal or remove the fuse. REMOVAL 1. Insert a remover tool (A) into the gap between luggage room lamp and luggage side lower finisher RH. 2. Disengage l ...

    P1652 starter motor system COMM
    Description ECM controls ON/OFF state of the starter relay, according to the engine and vehicle condition. Models with no Intelligent Key System transmit a control signal directly to IPDM E/R. On the other hand, models with the Intelligent Key System transmit a control signal to IPDM E/R by w ...

    Operation inspection
    Work Procedure The purpose of the operational check is to check that the individual system operates normally. Check condition : Engine running at normal operating temperature. 1.CHECK BLOWER MOTOR 1. Operate fan control dial. 2. Check that fan speed changes. Check operation for all fan speeds ...