Nissan Juke Service and Repair Manual : Operation inspection

Work Procedure

The purpose of the operational check is to check that the individual system operates normally.

Check condition : Engine running at normal operating temperature.

1.CHECK BLOWER MOTOR

1. Operate fan control dial.

2. Check that fan speed changes. Check operation for all fan speeds.

Is the inspection result normal? YES >> GO TO 2.

NO >> GO TO 6.

2.CHECK DISCHARGE AIR

1. Operate fan control dial to set the fan speed to maximum speed.

2. Operate MODE dial to each position.

3. Check that air outlets change according to each indicated air outlet by placing a hand in front of the air outlets. Refer to VTL-5, "System Description".

Is the inspection result normal? YES >> GO TO 3.

NO >> GO TO 6.

3.CHECK INTAKE AIR

1. Operate intake lever to each position.

2. Listen to intake sound and confirm air inlets change.

Is the inspection result normal? YES >> GO TO 4.

NO >> GO TO 6.

4.CHECK DISCHARGE AIR TEMPERATURE

1. Operate temperature control dial.

2. Check that discharge air temperature changes.

Is the inspection result normal? YES >> GO TO 5.

NO >> GO TO 6.

5.CHECK TEMPERATURE INCREASE

1. Turn temperature control dial to full hot position.

2. Check that warm air blows from air outlets.

Is the inspection result normal? YES >> INSPECTION END

NO >> GO TO 6.

6.CHECK SELF-DIAGNOSIS WITH CONSULT-III

1. Perform self-diagnosis with CONSULT-III.

2. Check that any DTC is detected.

Is any DTC detected? YES >> Perform trouble diagnosis for the detected DTC.

NO >> Refer to HAC-329, "Symptom Table" and perform the appropriate diagnosis.

    Diagnosis and repair workflow
    Work Flow OVERALL SEQUENCE DETAILED FLOW 1.INTERVIEW FOR MALFUNCTION Interview the symptom to the customer. >> GO TO 2. 2.SYMPTOM CHECK Check the symptom from the customer's informa ...

    DTC/circuit diagnosis
    Blower motor Diagnosis Procedure 1.CHECK SYMPTOM Check symptom (A or B). Which symptom is detected? A >> GO TO 2. B >> GO TO 7. 2.CHECK FUSE 1. Turn ignition switch OFF. 2. ...

    Other materials:

    Side curtain air bag module
    Exploded View 1. Side curtain air bag module : Metal clip : N·m (kg-m, ft-lb) Removal and Installation WARNING: • Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait 3 minutes or more. • Always work from the side of curtain air bag module. Never ...

    Remote keyless entry system
    System Diagram System Description DOOR LOCK AND UNLOCK OPERATION • When door lock and unlock button of keyfob is pressed, door lock and unlock signal transmits from keyfob to BCM via remote keyless entry receiver. • When BCM receives the door lock and unlock signal, it operates door loc ...

    Cylinder Head
    VALVE DIMENSIONS VALVE GUIDE VALVE SEAT *1: Diameter made by intersection point of conic angles “α1” and “α2” *2: Diameter made by intersection point of conic angles “α2” and “α3” *3: Machining data VALVE SPRING ...