Nissan Juke Owners Manual : Intelligent Key operating range

The Intelligent Key functions can only be used when the Intelligent Key is within


The Intelligent Key functions can only be used when the Intelligent Key is within the specified operating range from the request switch 1 .

When the Intelligent Key battery is discharged or strong radio waves are present near the operating location, the Intelligent Key system’s operating range becomes narrower, and the Intelligent Key may not function properly.

The operating range is within 31.50 in (80 cm) from each request switch1 .

If the Intelligent Key is too close to the door glass, handle or rear bumper, the request switches may not function.

When the Intelligent Key is within the operating range, it is possible for anyone who does not carry the Intelligent Key to push the request switch to lock/unlock the doors including the lift gate.

    Intelligent Key system (if so equipped)
    WARNING • Radio waves could adversely affect electric medical equipment. Those who use a pacemaker should contact the electric medical equipment manufacturer for the possible influences before ...

    Door locks/unlocks precaution
    • Do not push the door handle request switch with the Intelligent Key held in your hand as illustrated. The close distance to the door handle will cause the Intelligent Key system to have diff ...

    Other materials:

    Regulatory information
    Bluetooth trademark: Bluetooth® is a trademark owned by Bluetooth SIG, Inc., and licensed to Visteon Corporation. FCC Regulatory information • CAUTION: To maintain compliance with FCC’s RF exposure guidelines, use only the supplied antenna. Unauthorized antenna, modification, or attach ...

    Back door opener actuator
    Diagnosis Procedure 1.CHECK BACK DOOR OPENER ACTUATOR INPUT SIGNAL 1. Turn ignition switch OFF. 2. Disconnect back door opener assembly connector. 3. Check voltage between back door opener assembly harness connector and ground. Is the inspection result normal? YES >> GO TO 3. NO > ...

    Seat belt buckle switch signal circuit (driver side)
    Component Function Check 1.CHECK COMBINATION METER INPUT SIGNAL Select the “Data Monitor” for the “METER/M&A” and check the “BUCKLE SW” monitor value. BUCKLE SW When driver seat belt is fastened : Off When driver seat belt is unfastened : On >> INSPECTION END Diagnosis ...