Nissan Juke Service and Repair Manual : General Precautions

WARNING:
When replacing fuel line parts, be sure to observe the following.

• Put a “CAUTION: FLAMMABLE” sign in the workshop.

• Be sure to work in a well ventilated area and furnish workshop with a CO2 fire extinguisher.

• Never smoke while servicing fuel system. Keep open flames and sparks away from the work area.

CAUTION:
• Use diesel fuel required by the regulations for cetane number. Refer to GI-35, "Fuel".

• Before removing fuel line parts, perform the following procedures: - Put drained fuel in an explosion-proof container and put the lid on securely. Keep the container in safe area.

- Disconnect the battery cable from the negative terminal.

• Always replace O-ring and clamps with new ones.

• Never kink or twist tubes when they are being installed.

• Never tighten hose clamps excessively to avoid damaging hoses.

• After installing tubes, check that there is no fuel leakage at connections in the following steps.

- Start engine and rev it up and check for fuel leakage at connections.

• Use only a genuine NISSAN fuel filler cap as a replacement. If an incorrect fuel filler cap is used, the “MI” may come on.

    Other materials:

    P0850 PNP switch
    Description For CVT models, transmission range switch is turn ON when the selector lever is P or N. For M/T models, park/neutral position (PNP) range switch is ON when the selector lever is Neutral position. ECM detects the position because the continuity of the line (the ON) exists. DTC ...

    LATCH (Lower Anchors and Tethers for CHildren) system
    LATCH system lower anchor locations Your Nissan Leaf is engineered with dedicated anchor points designed for use with LATCH-compatible child restraints, a system also widely recognized as ISOFIX or ISOFIX-compatible. This system streamlines the installation process, el ...

    B2556 Push-button ignition switch
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Press push-button ignition switch under the following condition. - Brake pedal: Not depressed 2. Release push-button ignition switch and wait 100 seconds or more. 3. Check DTC in “Self Diagnos ...