Fuel system K9K

...

General Precautions

WARNING: When replacing fuel line parts, be sure to observe the following. • Put a “CAUTION: FLAMMABLE” sign in the workshop. • Be sure to work in a well ventilated area and furnish workshop with ...

Other materials:

Precaution Necessary for Steering Wheel Rotation after Battery Dis
NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always use CONS ...

Engine stand setting
Preparing the engine to be on the stand Before the engine is mounted on the engine sub-attachment, the engine's electrical harness must be removed and the engine oil drained. 1. Remove the multifunction support. 2. Remove the coolant inlet pipe on the water pump. 3. Place the rods (A), ...

B1001, B1002, B1003, B1004, B1005 diagnosis sensor unit
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...