Nissan Juke Service and Repair Manual : Electric controlled coupling

The electric controlled coupling operates as the 4WD system. For the operation, refer to DLN-15, "Operation Principle".

    Sectional View
    1. 4WD solenoid (RH) 2. Pinion rear bearing 3. Collapsible spacer 4. Pinion front bearing 5. Companion flange 6. Drive pinion 7. Gear carrier 8. Drive gear 9. 4WD solenoid (LH) 10. El ...

    Symptom diagnosis
    NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING NVH Troubleshooting Chart Use the chart below to find the cause of the symptom. If necessary, repair or replace these parts. ×: Applic ...

    Other materials:

    P2119 electric throttle control actuator
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.PERFORM DTC CONFIRMATION PROCEDURE ...

    P1553 battery current sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON. 3. ...

    Information display (speed limiter))
    Component Function Check 1.CHECK INFORMATION DISPLAY (SPEED LIMITER) FUNCTION 1. Start engine. 2. Press speed limiter MAIN switch. 3. Drive the vehicle at more than 30 km/h (20 MPH). CAUTION: Always drive vehicle at a safe speed. 4. Press SET/ACCELERATE or SET/COAST switch. 5. Perform a te ...