Nissan Juke Service and Repair Manual : ECM

Removal and Installation

REMOVAL

1. Remove fusible link bracket. Keep a service area.

2. Disconnect ECM harness connectors. Refer to PG-4, "Harness Connector".

3. Remove ECM mounting nuts, and then remove ECM.

INSTALLATION

Install in the reverse order of removal.

CAUTION:
Must be perform additional service when replacing ECM. Refer toEC-133, "Work Procedure".

    Fuel pump control modul (FPCM)
    Removal and Installation REMOVAL 1. Remove Luggage side lower finisher LH. Refer to INT-31, "LUGGAGE SIDE LOWER FINISHER : Removal and Installation". 2. Disconnect fuel pump control mo ...

    Other materials:

    P0504 ASCD brake SWI
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK GROUND CONNECTIONS 1. Turn ignition switch OFF and wait at least 20 seconds. 2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit Inspection". Is the inspection result normal? YES >> GO TO ...

    P0225 APP sensor
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC P0225 is displayed with DTC P0641, first perform trouble diagnosis for DTC P0641. Refer to EC-974, "DTC Logic". Diagnosis Procedure 1.CHECK GROUND CONNECTIONS 1. Turn ignition switch OFF. 2. Check ground connection E38. Refer to Gr ...

    P181B incomplete selfshut
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE W ...