Nissan Juke Service and Repair Manual : U1000 can comm circuit

Description

CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern vehicle is equipped with many electronic control unit, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN-H line, CAN-L line) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only.

CAN Communication Signal Chart. Refer to LAN-31, "CAN COMMUNICATION SYSTEM : CAN Communication Signal Chart".

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure


Diagnosis Procedure

1.PERFORM SELF DIAGNOSTIC

1. Turn the ignition switch ON and wait for 2 seconds or more.

2. Check “Self Diagnostic Result” of IPDM E/R.

Is DTC “U1000” displayed? YES >> Refer to LAN-17, "Trouble Diagnosis Flow Chart".

NO >> Refer to GI-42, "Intermittent Incident".

    B2098 ignition relay on stuck
    Description • IPDM E/R operates the ignition relay when it receives an ignition switch ON signal from BCM via CAN communication. • Turn the ignition relay OFF by pressing the push-button ignition ...

    Other materials:

    Removal and installation
    HORN Exploded View WITHOUT VEHICLE SECURITY SYSTEM 1. Horn high 2. Horn low 3. Horn bracket WITH VEHICLE SECURITY SYSTEM 1. Horn low 2. Horn bracket Removal and Installation REMOVAL Without Vehicle Security System 1. Remove the front center grille and front side grille (LH/RH). Re ...

    The ambient temperature display is incorrect
    Description • The displayed ambient air temperature is higher than the actual temperature. • The displayed ambient air temperature is lower than the actual temperature. Diagnosis Procedure NOTE: Check that the symptom is not applicable to the normal operating condition before starting diagn ...

    Removal and Disassembly
    • When instructed to use SST, use specified tools. Always be careful to work safely, avoid forceful or uninstructed operations. • Exercise maximum care to avoid damage to mating or sliding surfaces. • Dowel pins are used for several parts alignment. When replacing and reassembling parts with ...