Nissan Juke Owners Manual : Continuously Variable Transmission (CVT) fluid
When checking or replacement is required, we recommend a NISSAN dealer for servicing.
CAUTION
• Use only Genuine NISSAN CVT Fluid NS-2. Do not mix with other fluids.
• Using transmission fluid other than Genuine NISSAN CVT Fluid NS-2 will damage the CVT, which is not covered by the NISSAN new vehicle limited warranty.
Changing engine oil and filter
Change the engine oil and filter according to the maintenance log shown in the
NISSAN Service and Maintenance Guide.
Vehicle set-up
1. Park the vehicle on a level surface and apply the parking bra ...
Brake and clutch (if so equipped) fluid
For additional brake and clutch fluid information, see “Capacities and recommended
fuel/lubricants” of this manual.
WARNING
• Use only new fluid from a sealed container. Old, inferior or con ...
Other materials:
Chassis maintenance
Headlamp aiming adjustment (halogen type - LHD)
HEADLAMP AIMING ADJUSTMENT (HALOGEN TYPE - LHD) : Description
PREPARATION BEFORE ADJUSTING
NOTE:
• For details, refer to the regulations in your own country.
• Perform aiming if the vehicle front body has been repaired and/or the headlamp
assemb ...
Sample/Wiring Diagram -Example-
Each section includes wiring diagrams.
Description
SWITCH POSITIONS
Switches are shown in wiring diagrams as if the vehicle is in the “normal”
condition.
A vehicle is in the “normal” condition when:
• ignition switch is “OFF”,
• doors, hood and trunk lid/back door are closed,
• peda ...
B2098 ignition relay on stuck
Description
• IPDM E/R operates the ignition relay when it receives an ignition switch ON
signal from BCM via CAN communication.
• Turn the ignition relay OFF by pressing the push-button ignition switch once
when the vehicle speed is 4 km/
h (2.5 MPH) or less.
• Turn the ignition relay OFF w ...
