Nissan Juke Owners Manual : Cleaning

If your windshield is not clear after using the windshield washer or if a wiper blade chatters when running, wax or other material may be on the blade or windshield.

Clean the outside of the windshield with a washer solution or a mild detergent. Your windshield is clean if beads do not form when rinsing with clear water.

Clean each blade by wiping it with a cloth soaked in a washer solution or a mild detergent.

Then rinse the blade with clear water. If your windshield is still not clear after cleaning the blades and using the wiper, replace the blades.

CAUTION

Worn windshield wiper blades can damage the windshield and impair driver vision.

    Replacing
    Replace the wiper blades if they are worn. Before replacing the wiper blades, the wiper should be in the fully up position to avoid scratching the engine hood or damaging the wiper arm. To pull u ...

    Other materials:

    Precaution for Brake System
    WARNING: Clean any dust from the front brake and rear brake using a vacuum dust collector. Never blow by compressed air. • Brake fluid use refer to MA-13, "Fluids and Lubricants". • Never reuse drained brake fluid. • Never spill or splash brake fluid on painted surfaces. Brake ...

    How to normal charge (AC 220-240 volt) by L1 & L2 EVSE
    WARNING Adhering strictly to the following safety protocols is mandatory. Failure to observe these warnings may result in severe property damage, critical system failure, or life-threatening injury. If you are fitted with a pacemaker or an implantable cardiovascular defibrillator ...

    P17BB primary pressure solenoid
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.CHECK DTC DETECTION 1. S ...