Nissan Juke Service and Repair Manual : C1604 torque sensor

DTC Logic

DTC DETECTION LOGI

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

>> GO TO 2.

2.DTC REPRODUCTION PROCEDURE

1. Turn the ignition switch OFF to ON.With CONSULT-III


1. Turn the ignition switch OFF to ON.

2. Perform “EPS” self-diagnosis.

Is DTC “C1604” detected? YES >> Proceed to diagnosis procedure. Refer to STC-21, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK TERMINALS AND HARNESS CONECTORS

Check EPS control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace error-detected parts.

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace error-detected parts.

2.PERFORM SELF-DIAGNOSIS

1. Erase self-diagnostic results for “EPS”.With CONSULT-III


1. Erase self-diagnostic results for “EPS”.

2. Turn the ignition switch OFF, and then wait 10 seconds and more.

3. Perform self-diagnosis for “EPS”.

Is DTC “C1604” detected? YES >> Torque sensor is malfunctioning. Replace steering column assembly. Refer to ST-10, "Removal and Installation".

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    C1601 battery power supply
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least ...

    C1606 EPS motor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least ...

    Other materials:

    Heavy tight-corner braking symptom occurs
    Description Heavy tight-corner braking symptom occurs when the vehicle is driven and the steering wheel is turned fully to either side after the engine is started. NOTE: Light tight-corner braking symptom may occur depending on driving conditions. This is not malfunction. Diagnosis Proced ...

    U1000 can comm circuit
    Description CAN (Controller Area Network) is a serial communication line for real-time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent malfunction detection ability. Many electronic control units are equipped onto a vehicle, and ...

    Hood lock
    Exploded View 1. Hood lock control cable assembly 2. Hood lock assembly : Clip : N·m (kg-m, ft-lb) : Body grease Hood lock HOOD LOCK : Removal and Installation REMOVAL 1. Remove front center grille. Refer to EXT-18, "Removal and Installation". 2. Remove crash zone sensor. Ref ...