Connector information

How to Read Connector Type 1 : Connector model 2 : Cavity 3 : Male (M) and female (F) terminals 4 : Connector color 5 : Special type B Body Harness D Door Harness ...

Battery inspection

How to Handle Battery CAUTION: • If it becomes necessary to start the engine with a booster battery and jumper cables, use a 12-volt booster battery. • After connecting battery cables, ensur ...

Other materials:

Power supply and ground circuit
A/C auto AMP. : Diagnosis Procedure 1.CHECK SYMPTOM Check symptom (A or B). Which symptom is detected? A >>GO TO 2. B >>GO TO 5. 2.CHECK FUSE 1. Turn ignition switch OFF. 2. Check 10A fuse (No. 3, located in fuse block (J/B)]. NOTE: Refer to PG-22, "Fuse, Connector ...

Hazard function
Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “FLASHER” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Haz ...

Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW Work Flow OVERALL SEQUENCE DETAILED FLOW 1.OBTAIN INFORMATION ABOUT SYMPTOM Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurred. >> GO TO 2. 2.CHECK SYMPTOM • ...