Nissan Juke Service and Repair Manual : Additional service when replacing ECM

Description

When replacing ECM, this procedure must be performed.

Work Procedure

1.PERFORM INITIALIZATION OF NATS SYSTEM AND REGISTRATION OF ALL NATS IGNITION KEY IDS

Refer to SEC-50, "BCM : Special Repair Requirement" (With intelligent key system), SEC-190, "BCM : Work Procedure" (Without intelligent key system).

>> GO TO 2.

2.PERFORM ACCELERATOR PEDAL RELEASED POSITION LEARNING

Refer to EC-542, "Work Procedure".

>> GO TO 3.

3.PERFORM THROTTLE VALVE CLOSED POSITION LEARNING

Refer to EC-543, "Work Procedure".

>> GO TO 4.

4.PERFORM IDLE AIR VOLUME LEARNING

Refer to EC-544, "Work Procedure".

>> END

    Diagnosis and repair workflow
    Work Flow OVERALL SEQUENCE DETAILED FLOW 1.GET INFORMATION FOR SYMPTOM Get the detailed information from the customer about the symptom (the condition and the environment when the incident/ma ...

    Accelerator pedal released position learning
    Description Accelerator Pedal Released Position Learning is a function of ECM to learn the fully released position of the accelerator pedal by monitoring the accelerator pedal position sensor outp ...

    Other materials:

    Exhaust manifold
    Exploded View 1. Exhaust manifold cover 2. Harness bracket 3. Air fuel ratio sensor 1 4. Exhaust manifold stay 5. Heat insulator 6. Exhaust manifold 7. Exhaust manifold cover 8. Gasket : Engine front : Always replace after every disassembly. : N·m (kg-m, in-lb) : N·m (kg-m, f ...

    Radiator cap : Inspection
    Check valve seat (A) of radiator cap. B : Metal plunger - Check that valve seat is swollen to the extent that the edge of the plunger cannot be seen when watching it vertically from the top. - Check that valve seat has no soil and damage. Pull negative-pressure valve to open it, and that it c ...

    Precautions
    Liquid Gasket REMOVAL OF LIQUID GASKET SEALING • After removing mounting nuts and bolts, separate the mating surface using the seal cutter [SST: KV10111100 (J-37228)] (A) and remove old liquid gasket sealing. CAUTION: Be careful not to damage the mating surfaces. • Tap the seal cutter ...