Nissan Juke Service and Repair Manual : Additional service when replacing control unit

Description

BEFORE REPLACEMENT

When replacing BCM, save or print current vehicle specification with CONSULT-III configuration before replacement.

NOTE

:
If “READ CONFIGURATION” can not be used, use the “WRITE CONFIGURATION - Manual selection” after replacing BCM.

AFTER REPLACEMENT

CAUTION:
• When replacing BCM, you must perform “WRITE CONFIGURATION” with CONSULT-III.

- Complete the procedure of “WRITE CONFIGURATION” in order.

- If you set incorrect “WRITE CONFIGURATION”, incidents might occur.

- Configuration is different for each vehicle model. Confirm configuration of each vehicle model.

• When replacing BCM, perform the system initialization (NATS).

Work Procedure

1.SAVING VEHICLE SPECIFICATION

Perform “READ CONFIGURATION” to save or print current vehicle specification.CONSULT-III Configuration


Perform “READ CONFIGURATION” to save or print current vehicle specification. Refer to BCS-151, "Description".

NOTE: If “READ CONFIGURATION” can not be used, use the “WRITE CONFIGURATION - Manual selection” after replacing BCM.

>> GO TO 2.

2.REPLACE BCM

Replace BCM. Refer to BCS-161, "Removal and Installation".

>> GO TO 3.

3.WRITING VEHICLE SPECIFICATION

Perform “WRITE CONFIGURATION - Config file” or “WRITE CONFIGURATION - ManualCONSULT-III Configuration


Perform “WRITE CONFIGURATION - Config file” or “WRITE CONFIGURATION - Manual selection” to write vehicle specification. Refer to BCS-151, "Work Procedure".

>> GO TO 4.

4.INITIALIZE BCM (NATS)

Perform BCM initialization. (NATS) >> WORK END

    Configuration (bcm)
    Description Vehicle specification needs to be written with CONSULT-III because it is not written after replacing BCM. Configuration has three functions as follows. NOTE: Manual setting item: I ...

    Other materials:

    P0089 fuel pump
    DTC Logic DTC DETECTION LOGIC NOTE: • Conditions for applying the diagnostic procedure to the stored DTCs: The DTC becomes present during the first 30 seconds after the engine starts. • In low ambient temperature conditions, diagnostic cannot make difference between a normal long engine ...

    Fuel level sensor signal circuit
    Component Function Check 2WD MODELS 1.CHECK COMBINATION METER OUTPUT SIGNAL Select the “Data Monitor” for the “METER/M&A” and compare the “FUEL METER” monitor value with the fuel gauge reading on the combination meter. Does monitor value match fuel gauge reading? YES >&g ...

    Unlock sensor
    Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “UNLK SEN -DR” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >&g ...