RHD

RHD : Wiring Diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Connector Information ...

Additional service when replacing control unit

Description BEFORE REPLACEMENT When replacing BCM, save or print current vehicle specification with CONSULT-III configuration before replacement. NOTE: If “READ CONFIGURATION” can not be used ...

Other materials:

Cooling fan control
Cooling fan control : System Diagram Cooling fan control : System Description INPUT/OUTPUT SIGNAL CHART *: The ECM determines the start signal status by the signals of engine speed and battery voltage. SYSTEM DESCRIPTION ECM controls cooling fan speed corresponding to vehicle speed, eng ...

Removal and installation
REAR WHEEL HUB Exploded View 1. Rear suspension beam 2. Rear brake assembly 3. Hub bolt 4. Wheel hub assembly (Bearing-integrated type) 5. Disc rotor 6. Plug : Always replace after every disassembly. : N·m (kg-m, ft-lb) Removal and Installation REMOVAL 1. Remove tires. Refer to W ...

Blower motor
Diagnosis Procedure 1.CHECK FUSE 1. Turn ignition switch OFF. 2. Check following fuses. - 10A fuse [No. 15, located in fuse block (J/B)] - 15A fuses [Nos. 14 and 16, located in fuse block (J/B)] NOTE: Refer to PG-22, "Fuse, Connector and Terminal Arrangement". Is the inspection ...