Nissan Juke Service and Repair Manual : Wiring diagram

POWER WINDOW SYSTEM

LHD

LHD : Wiring Diagram

For connector terminal arrangements, harness layouts, and alphabets in a described in wiring diagram), refer to GI-12, "Connector Information/Explanation(option abbreviation; if not
described in wiring diagram), refer to GI-12, "Connector Information/Explanation of Option Abbreviation".

RHD


RHD

RHD : Wiring Diagram

For connector terminal arrangements, harness layouts, and alphabets in a described in wiring diagram), refer to GI-12, "Connector Information/Explanation (option abbreviation; if not
described in wiring diagram), refer to GI-12, "Connector Information/Explanation of Option Abbreviation".

Basic inspection


    Power window main switch
    Reference Value TERMINAL LAYOUT PHYSICAL VALUES POWER WINDOW MAIN SWITCH Fail Safe FAIL-SAFE CONTROL Switches to fail-safe control when malfunction is detected in encoder signal that det ...

    Other materials:

    Assembly and Installation
    • Use torque wrench to tighten bolts or nuts to specification. • When tightening nuts and bolts, as a basic rule, equally tighten in several different steps starting with the ones in center, then ones on inside and outside diagonally in this order. If the order of tightening is specified, do ...

    Basic inspection
    DIAGNOSIS AND REPAIR WORK FLOW Work Flow OVERALL SEQUENCE DETAILED FLOW NOTE: If any malfunction is found, immediately disconnect the battery cable from the negative terminal. 1.CHECK ENGINE START Crank the engine and check that the engine starts. Does the engine start? YES >> ...

    Inspection
    INSPECTION AFTER REMOVAL Check the following items, and replace the part if necessary. • Move joint up/down, left/right, and in the axial directions. Check for motion that is not smooth and for significant looseness. • Check boot for cracks, damage, and leakage of grease. • Check the suppor ...