Nissan Juke Service and Repair Manual : Thermostat

Engine Control System MR16DDT


    Radiator
    ...

    Other materials:

    P0340 CMP sensor (PHASE)
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...

    P1829 accelerator pedal position sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With ...

    Heater control
    Exploded View 1. Intake door cable 2. Air mix door cable 3. Mode door cable 4. Heater control 5. Intake door lever knob A. To intake door link B. To air mix door link C. To mode door link Removal and Installation REMOVAL 1. Remove A/C finisher. Refer to IP-13, "Removal and Ins ...